How Many Blend Door Actuator in Chevrolet Silverado

How many blend door actuator in Chevrolet Silverado? There are four. The two on the driver’s side control the airflow to the front and rear of the vehicle.

The passenger’s side controls the airflow to the floor and defrost vents.

If you’re driving a Chevrolet Silverado, then you likely have a blend door actuator somewhere in your truck. But how many blend door actuators does a Silverado have? The answer may surprise you – there are actually four blend door actuators in a Chevrolet Silverado!

Two of them are located in the front of the truck, near the dash, and two are located in the back, near the tailgate. Each of these blend door actuators is responsible for controlling a different air vent: one controls the driver’s side vents, one controls the passenger’s side vents, one controls the center vents, and one controls the rear vents. So if you’re ever having trouble with any of your truck’s air vents, it could be due to a faulty blend door actuator.

Fortunately, replacing a blend door actuator is relatively easy and inexpensive. So if you think yours might be going bad, don’t hesitate to get it replaced – it could make all the difference in your truck’s comfort level!

2007 Chevy Silverado Blend Door Actuator Location

If you’re looking for the 2007 Chevy Silverado blend door actuator, it’s located on the driver’s side of the vehicle, just behind the glove box. To access it, simply remove the glove box and look for a small black motor with a white plastic gear attached to it. This is the actuator that controls the blend door, which regulates the mix of hot and cold air that comes into the cabin.

Is There More Than One Blend Door Actuator?

Most cars have two or more blend door actuators. The actuator controls the position of the door, which in turn controls how much air is directed to the various vents in the car. For example, when you turn on the AC, one of the doors closes to direct all the air through the vents and into the cabin.

Where are the Blend Door Actuators Located?

If your vehicle’s heater isn’t working properly, the first thing you should check are the blend door actuators. These small motors are responsible for opening and closing the doors that control the airflow in your HVAC system. Depending on your vehicle, there may be one or two of these actuators.

They are usually located behind the glove box or under the dash. To check if they are working properly, you will need to access them. This can be done by removing the glove box or a panel under the dash.

Once you have access to the actuators, you can test them with a multimeter. If they are not working properly, they will need to be replaced.

Where is the Blend Door Actuator on a 2009 Silverado?

Assuming you are referring to the HVAC blend door actuator: The actuator is located on the passenger side of the vehicle, behind the glove box. To access it, you will need to remove the glove box door and liner.

Once these are removed, you should be able to see and access the actuator.

How Do You Change the Blend Door Actuator on a 2002 Chevy Silverado?

If you’re having trouble with your blend door actuator on your 2002 Chevy Silverado, there are a few things you can do to try and fix it. First, check the fuse box under the hood to see if there is a blown fuse. If there is, replace it and see if that fixes the problem.

If not, then you’ll need to remove the glove box and locate the actuator. It’s usually located on the right side of the heater box. Once you’ve found it, unplug the electrical connector and remove the two screws that hold it in place.

Then, simply reverse these steps to install the new actuator.


According to the blog post, there are four blend door actuators in the Chevrolet Silverado. The first two are located in the center of the vehicle, behind the glove box. The third is located in the passenger side footwell, and the fourth is located in the driver side footwell.

All four actuators are responsible for controlling the flow of air into and out of the cabin.

Leave a Comment

Your email address will not be published. Required fields are marked *